QUESTION 31
Click the Exhibit button. A technician is asked to review the existing trunk information for a customer.
According to the Element manager screen capture shown in the exhibit, which type of trunk is this?
A. DID
B. VIRTUAL
C. RAN
D. H 323
Answer: B
QUESTION 32
A customer with a Communication Server (CS) 1000Rls. 6.0 SA is upgrading to Release 7.0. They have decided to replace the existing CPPM Call server CPPM Signaling Server with a CPPM Co- Resident Call Server, Signaling Server and Gateway Controller to free up a two card slots. A technician has decided to use the ELAN IP of the Call Server from the original system as the ELAN IP address of the Co-Resident server.
Which action must be taken to consolidate the servers?
A. Re-configure the Call Server IP address field in each Media gateway Controller
B. Re-configure the Telephony Node Information to reflect the Call Server ELAN IP
C. Re-configure the DSP Daughterbaords to reflect Call Server ELAN IP.
D. Re-configure the network Routing Service to reflect the Call Server ELAN IP address.
Answer: A
QUESTION 33
Click the Exhibit button. A technician is asked to review the existing route information for the customer.
According to the printout shown in the exhibit, type of route is this?
A. A direct inward dial route
B. An analog route
C. A media services route
D. An outgoing only route
Answer: C
QUESTION 34
A customer has a Communication Server (CS) 1000 Rls. 7x Co-Resident system with a Media Gateway Controller and Media Cards and has completed the configuration of all elements and they are all active and known to the Call Server. The customer wants to add all the elements to the Security Domain.
Which Overlay 117 commands used to add the element to the Security Domain?
A. JoinSecDomain
B. Join ucmSecurity element
C. Register ucmsecurity device
D. Register ucmSecurity system
Answer: D
QUESTION 35
A customer is planning to install and configure a Commercial Off the Shelf (COTS) server IBM X3550 as a Signaling Server for their Communication Server (CS) 1000 Rls.. 7x network.
Which two statements describe the software installation process? (Choose two)
A. Before Linux Base software, the COTS server must be configured as a member server.
B. Application software is loaded onto the COTS server using Deployment Manager.
C. Linux Base software and application software are pre-loaded onto the COTS server at the factory
D. Linux Base software is installed using command line interface and a bootable DVD containing
software and operating system
Answer: BD
QUESTION 36
A customer with an existing Option 11C Rls. 5.5 chassis system plans to upgrade to a Communication Server (CS) 1000E Rls. 7x Standard Availability with a single IP Media Gateway (MG) 1000E chassis.
To complete the upgrade, which component in the Option 11C must be replaced?
A. SSC Card
B. Call Processor
C. Media Gateway
D. Digital Line Card
Answer: A
QUESTION 37
A field calls about a problem enabling the DSPs on a new Communication Server (CS) 1000E SA Co-resident on release 7x. The DSPs on the MG 1 are all enabled but enabling the DSPs on MG2 and MG3 fail, and asked that the configuration be reviewed.
MG1: CPMG 128
MG2: MGC 128 DSP DB in position 2
MG3: MGC 128 DSP DB in position 2
After reviewing the configuration, an error in the DSP 128 VGW (DSP) configuration is identified?
Which configuration option accurately reflects the proper configuration for the voice Gateway (DSP) channel?
A. Numbering of VGW channels: 128
Trunk data block VGW
Terminal number: 004 0 02 0
Designator field for trunk: DSP
Extended trunk DSP DB 128
Customer number: 00
B. Numbering of VGW channels: 128
Trunk data block VGW
Terminal number: 004 0 01 0
Designator field for trunk: DSP
Extended trunk DSP DB 128
Customer number: 00
C. Numbering of VGW channels: 128
Trunk data block VGW
Terminal number: 004 0 00 0
Designator field for trunk: DSP
Extended trunk DSP DB 128
Customer number: 00
D. Numbering of VGW channels: 128
Trunk data block VGW
Terminal number: 004 0 11 0
Designator field for trunk: DSP
Extended trunk DSP DB 128
Customer number: 00
Answer: D
QUESTION 38
A Communication Server (CS) 1000E Rls. 7x customer has decided to implement UNIStim security with DTLS.
Which statement regarding UNIStim security with DTLS is true?
A. It is provided by the Secure Multimedia Controller 2450.
B. It encrypts UNIStim signaling between the line Terminal Proxy Server and IP telephones.
C. It provides media security between the IP telephones.
D. It provides security between the Ip telephone and Call Server.
Answer: B
QUESTION 39
A customer with a Communication Server (CS) 1000E at Rls. 5.5 with two IPMG is upgrading the system to CS 1000E SA release 7 x. The second media gateway includes a media Gateway Controller card with one high density DSP daughter board.
How many voice channels does this configuration provide?
A. 32
B. 64
C. 96
D. 128
Answer: C
QUESTION 40
Refer to the exhibit. A Communication Server 1000E Rls. 7 x customer is adding a new Human Resources department with eight IP telephone users. The customer has asked for the telephones to be programmed with consecutive Directory numbers (DNs) from their DID range (2000-2099).
Which numbers sequence is available to meet the customer’s requirements?
A. 2001-2008
B. 2010-2017
C. 2050-5057
D. 5091-2098
Answer: D
…go to http://www.lead2pass.com/7003.html to download the full version Q&As.
