Tag: 350-030 Practice Tests

QUESTION 131 An IP Phone appears to be registered to the Cisco CME system in “show ephone registered”. However, it can not make any outgoing…

QUESTION 121 When deploying IPMA in proxy mode, what is the minimum number of partitions and calling search spaces required? A.    3 partitions and 1…

QUESTION 111
Bob’s Bicycles is configuring Unity as an Auto Attendant. The requirements are for outside callers to hear a prompt saying “Press 1 for Sales, Press 2 for Service, Press 3 for News and Events”. If they Press 1, they reach a submenu where they are prompted to “Press 1 for Bike Sales, Press 2 for Accessories”. If they Press 1, Unity should list the 4 sales people and allow the caller to choose. If they press 2 from the initial prompt they reach a submenu where they are prompted to “Press 1 to schedule an appointment or Press 2 to check the status of your repair”. At anytime the caller should be able to press 0 and be transferred to the Operator. What is the minimum number of Call Handlers required?

A.    7
B.    8
C.    9
D.    10
E.    11

Answer: B

QUESTION 101 Which of the following are NOT true statements about Certificate Trust List (CTL) File? (Choose Two) A.    It is a list of devices…

QUESTION 91 Which of the following statements outline the correct way to implement a non-standard softkey template? A.    Select a softkey template; copy the template…

QUESTION 81 When implementing a Cisco Unified Communications Manager solution over an MPLS WAN, which two rules must be observed to prevent overrunning the priority…

QUESTION 71 What will occur if a video bridge is not available during a video call setup on Cisco Unified Communications Manager using the Intelligent…

QUESTION 61 According to the IEEE 802.3af PoE standard, what is the maximum power (in watts) that is delivered to a power-consuming device? A.    6.3…

QUESTION 51
Which SCCP message is used to instruct to an SCCP IP Phone the remote IP address and port number to send RTP packets?

A.    Station IP Port Message
B.    Station Open Receive Channel message
C.    Station Start Media transmission message
D.    Station Call information message.
E.    Station Open Logical Channel message

Answer: C

QUESTION 41 In a VoIP deployment, which two protocols satisfy the following three requirements? (Choose two) Requirement 1: the protocol has a mechanism for a…

QUESTION 31 Which three of these are possible reasons why a JTAPI subsystem might have the status PARTIAL_SERVICES? (Choose Three) A.    Cisco Unified Contact Center…

QUESTION 21 Given a Catalyst 3550 configured to support IPT, which configuration would correctly identify voice and call signaling traffic originating from a Cisco IP…

QUESTION 11 Refer to the shown output. Calls to the PSTN are being rejected. Which of the following will correct this issue? A.    Add the…